Home › Tap and Mixer Repairs in Mulgrave

Taps and mixers · Mulgrave VIC 3170

Tap and Mixer Repairs in Mulgrave

A dripping tap wastes water and keeps you awake. We repair and replace taps and mixers in kitchens, bathrooms and laundries across Mulgrave, using WaterMark certified parts. Call 03 9088 4762.

Urgent calls answered · Mulgrave VIC 3170

Tap cartridge, washers and screwdriver laid out on a towel while a plumber removes a laundry tap handle

Common tap problems

  • Taps that drip from the spout after being turned off.
  • Water leaking from around the handle or the base of the tap.
  • Stiff or loose handles that are hard to turn.
  • Mixers that are hard to set to the right temperature, or swing hot and cold.
  • Low flow from a tap that used to run well.
  • Outside garden taps leaking or seized.
  • Shower mixers that drip or will not turn off fully.

Older taps and newer mixers

Many Mulgrave homes built in the 1970s and 80s still have traditional two-handle taps with rubber washers and jumper valves inside. These are usually simple to repair by replacing the washer, the jumper valve or reseating the valve seat if it has worn. Newer homes and renovated bathrooms are more likely to have single-lever mixers with ceramic cartridges. A worn cartridge is replaced as a unit.

When we repair a tap, we bring a range of washers, cartridges and spindles. If the tap is very old or parts are no longer available, replacement can be better value.

New tapware

If you are replacing tapware, we can install kitchen mixers with pull-out sprays, filtered water taps, wall-mounted bath and laundry mixers, shower systems and outdoor taps. We check the existing connections, make sure the new tapware suits your water pressure and install isolation valves where needed so future maintenance is easier.

High pressure and dripping taps

If several taps in the house drip or wear out quickly, the mains pressure may be too high. That is common in some newer parts of the area. A pressure test takes a few minutes, and a pressure limiting valve can protect the whole house. See our water pressure page.

Why fix a dripping tap quickly

A single dripping tap can waste thousands of litres a year. Hot taps that drip also waste the energy used to heat the water. And a drip that is ignored usually gets worse, wearing the valve seat and making the repair bigger. ## Outdoor taps

Garden taps take a beating from weather, hoses and the occasional bump from a car or mower. We replace seized or leaking garden taps, fit hose connectors properly and check that taps near the house are securely fixed so they do not move and crack the pipe behind the wall. Where irrigation connects to a tap, we can fit the right backflow protection.

Tapware and WaterMark

Only install tapware that carries WaterMark certification. Cheap uncertified taps can leach metals into drinking water, fail early and void insurance cover.

Ask to see the WaterMark logo on the box or product listing before you buy.

Local knowledge

What we see in Mulgrave properties

Mulgrave grew quickly from the late 1960s, and most streets are lined with brick-veneer houses from the 1970s and 1980s, many now sharing their blocks with two or three newer units. Underneath them is heavy, reactive clay that swells in wet winters and shrinks in dry summers, which is hard on old earthenware sewer joints and on stormwater pipes laid before flexible fittings were common. Off Wellington Road in the north-east, the Waverley Park estate is far newer, with plastic pipe, tempering valves and pressure that often needs a limiting valve. Then there is the business precinct along Wellington and Ferntree Gully Roads, where offices, warehouses and food businesses need backflow testing and washroom work. Knowing which of those you are dealing with before we arrive is half the job.

What you get

Included with every tap and mixer repairs visit

Diagnosis
Camera, gauge, thermal imager or meter test chosen to suit the fault, with the result shown to you
Price
Agreed before any work, and written down for bigger jobs
Who turns up
A licensed, insured Victorian plumber who works in Mulgrave every week
Parts
WaterMark certified products installed to Australian standards
Records
Compliance certificate for regulated work, plus photos or drain footage if you want them
Finish
Everything tested in front of you, old parts taken away and the area left clean

Questions and answers

Tap and Mixer Repairs in Mulgrave: your questions

Can a dripping tap be repaired, or does it need replacing?

Most dripping taps can be repaired by replacing a washer, jumper valve or cartridge. Very old or damaged taps may be better replaced.

Why is water leaking from the tap handle?

Usually a worn O-ring or gland seal around the spindle, which we replace.

Do you supply tapware?

We can supply quality WaterMark certified tapware or install tapware you have chosen, as long as it is certified for use in Australia.

Why do my taps keep dripping after repairs?

High water pressure or a worn valve seat can cause repeat drips. We test pressure and reseat or replace parts as needed.

Can you fix a dripping shower mixer?

Yes. Most shower mixers have a replaceable cartridge or washer set that we can change without removing tiles.

Getting ready

Five ways to speed up our visit

  • Locate the meter Most Mulgrave meters sit near the front boundary, often under a small lid in the nature strip or garden bed. Units usually have a bank of meters near the driveway; check which one is yours.
  • Make room Clear cars from the driveway and move bins, boxes or bikes away from the laundry, hot water unit, toilet or drain openings we will need.
  • Tell us the pattern Which taps, drains or rooms are affected, when it began and whether anything changed recently, like a renovation, a new appliance or heavy rain.
  • Access and pets Mention locked side gates, dogs, intercoms, body corporate rules or loading-dock access for commercial sites.
  • Send a photo A picture of the leak, the hot water label or two meter readings taken an hour apart can save time and a second trip.

Free quote

Tell us about the job

Send a few details and a licensed Mulgrave plumber will phone you back. If water is escaping right now, call 03 9088 4762 instead.

03 9088 4762

We do not publish prices. We look at the job, explain the options and agree the cost with you before any work starts.







    How a job runs

    From your first call to the finished job

    1. 01
      Call or send the form

      Tell us what is happening, where it is and how urgent it feels. A phone photo of the problem, the hot water label or the meter helps us bring the right parts.

    2. 02
      Diagnose and price

      We test rather than guess, show you what we found and give you a fixed price for the fix. Nothing starts until you say yes.

    3. 03
      Do the work properly

      Repairs and installs follow the Plumbing Code of Australia and Victorian rules, with WaterMark certified parts and materials.

    4. 04
      Test and hand over

      We run everything with you, clean up, take the old parts and leave notes, photos and a compliance certificate when one applies.

    Where we work

    Mulgrave and the suburbs around it

    Our base is Mulgrave itself, between the Monash Freeway and Police Road. From here, Waverley Park and Wheelers Hill are a few minutes north and east, Glen Waverley is up Springvale Road, Clayton sits to the west, Springvale and Noble Park North are to the south and Dandenong North and Rowville are across Dandenong Creek to the east. If your street is nearby but not listed, ring 03 9088 4762 and ask.

    Mulgrave Plumbing

    Leak, blockage or no hot water? Talk to a local plumber now.